triadakingdom.blogg.se - Ultimaker cura creality ender 3 v2

#Ultimaker cura creality ender 3 v2 install
#Ultimaker cura creality ender 3 v2 manual

CAUTION Select the correct input voltage on the power supply, If not set correctly this can damage your printer!.

Slide the extruder knob onto the top of the extruder stepper motor shaft.

Push the covers onto the ends of the top gantry profile.

Push the collar on the Extruder in, slide the Bowden tube fully in, release the collar and secure with the clip on spacer.

Assemble the filament holder and attach it to the top profile with 2 M5x8 screws and T Nuts (flat side to the back).

#Ultimaker cura creality ender 3 v2 install

Install Filament holder, covers, Bowden tube and Extruder knob

Attach the display screen to the right side of the frame, connecting the cable.Install the top gantry profile using 4 M5x25 screws.Adjust the tension of the drive belts, not too tight but taught.Slide the V pulleys into the vertical profiles along with threading the lead screw into the Brass nut on the Extruder assembly.Thread the drive belt through the tensioner, Attach the tensioner to the X axis Gantry and attach the ends of the belt into the slots on the Nozzle assembly.Screw the Z axis Roller bracket assembly onto the X axis profile using 2 M4x16 screws.Slide the Nozzle assembly onto the X axis profile over the drive belt.Wrap the drive belt around the pulley in the XE-axis Assembly.Bolt the XE-axis Assembly onto the X axis profile using 2 M4x16 screws.Fit the pneumatic joint into the Extruder.Insert the Lead screw into the motor coupler and tighten.Attach the Z axis motor to the left hand Z profile with 2 M4x18 screws into the bottom holes on the profile.Install Z-axis Motor Assembly and Lead Screw Tighten the limit switch at it’s lowest position.Slide the Z axis limit switch onto the left Z-Axis profile (2 holes at the bottom) and use the M5x45 screws to secure the profiles to the base.Install Z-axis Limit Switch Assembly and Z-axis Profiles Full and detailed assembly instructions is available here. This guide contains a quick summary of the assembly steps.

#Ultimaker cura creality ender 3 v2 manual

We still recommend that you read through the User Manual before starting assembly and use. This Ender-3 V2 3D Printer Quick Start Guide is designed to aid Ender-3 V2 users in the assembly and use of their new printer and to help in getting started with 3D Printing.

Selecting and modifying the Print ProfileĬongratulations on your purchase of the Ender-3 V2 3D Printer from SainSmart.

Install Filament holder, covers, Bowden tube and Extruder knob.

Install Z-axis Motor Assembly and Lead Screw.

Install Z-axis Limit Switch Assembly and Z-axis Profiles.